Find a bracelet that fits you correctly. Set it down flat. Measure with a ruler the length from the top of the clasp to the end of the bracelet. Make a note of the measurement. Order your Aporro bracelet in a size as close as possible to this measurement.
CHOOSING A BRACELET SIZE BY MEASURING YOUR WRIST
STEP 1: PLACE THE MEASURING TAPE
Wrap the tape measure around the wrist on which you plan to wear your bracelet. Make a note of the number at the point where the tape meets the 0.
STEP 2: CHOOSE THE RIGHT SIZE
After sizing ,To ensure the bracelet fits comfortably, add 1.5 cm. You can then add or subtract centimetres according to whether you prefer a loose, exact or tight fit.
HOW TO USE THE APORRO WRIST SIZER
STEP 1: OPEN AND PRINT PDF IN 100% SCALE
Start with opening the pdf file which you find when clicking the 'Bracelet Measuring PDF'. Make sure the pdf is scaled 100% and then print it.
Bracelet Measuring PDF
STEP 2: CHECK THE PRINTED FILE IS THE CORRECT SIZE WITH A CREDIT CARD
Check that the printed PDF file is the right size with your credit card or a card that has the same size as a credit card. Place the card in between the two arrows on the upper right-hand side of the paper. If the card fits perfectly in between the arrows you know that the printed PDF is the right size.
STEP 3: CUT OUT THE MEASURING RULER
Cut out the measuring stick from your printed measuring guide.
STEP 4: CUT THE DOTTED LINE
Make a short cut on the dotted line. Make sure not to cut all the way through, just enough to leave a hole in the paper. To make it easier you can fold the paper in half and cut on the dotted line.
STEP 5: PULL THE THINNER END THROUGH THE HOLE
Pull the thinner end of the cut-out ruler through the hole in the paper, so you create a loop with the paper. Make sure that you have the number on the outside so you can read your size.