NECKLACES VARY BY LENGTH AND CAN BE CHOSEN TO REFLECT PERSONAL PREFERENCE OR STYLE.* For Chokers, Add Two Inches To Whatever Your Neck Measurement Is For A Comfortable Fit.SHOP NECKLACE>>>
* Adding Four Inches To Your Neck Measurement Will Give You A Good Length For An Average Necklace, Like A Pendant.
INCH CM 6 15 6.5 17 7 18 7.5 19 8 20 8.5 22 9 23 9.5 24 10 25CHOOSING A BRACELET SIZE USING ANOTHER BRACELET
Find a bracelet that fits you correctly. Set it down flat. Measure with a ruler the length from the top of the clasp to the end of the bracelet. Make a note of the measurement. Order your Aporro bracelet in a size as close as possible to this measurement.CHOOSING A BRACELET SIZE BY MEASURING YOUR WRISTSTEP 1: PLACE THE MEASURING TAPEWrap the tape measure around the wrist on which you plan to wear your bracelet. Make a note of the number at the point where the tape meets the 0.STEP 2: CHOOSE THE RIGHT SIZEAfter sizing ,To ensure the bracelet fits comfortably, add 1.5 cm. You can then add or subtract centimetres according to whether you prefer a loose, exact or tight fit.HOW TO USE THE APORRO WRIST SIZERSTEP 1: OPEN AND PRINT PDF IN 100% SCALEStart with opening the pdf file which you find when clicking the 'Bracelet Measuring PDF'. Make sure the pdf is scaled 100% and then print it. Bracelet Measuring PDFSTEP 2: CHECK THE PRINTED FILE IS THE CORRECT SIZE WITH A CREDIT CARDCheck that the printed PDF file is the right size with your credit card or a card that has the same size as a credit card. Place the card in between the two arrows on the upper right-hand side of the paper. If the card fits perfectly in between the arrows you know that the printed PDF is the right size.STEP 3: CUT OUT THE MEASURING RULERCut out the measuring stick from your printed measuring guide.STEP 4: CUT THE DOTTED LINEMake a short cut on the dotted line. Make sure not to cut all the way through, just enough to leave a hole in the paper. To make it easier you can fold the paper in half and cut on the dotted line.STEP 5: PULL THE THINNER END THROUGH THE HOLEPull the thinner end of the cut-out ruler through the hole in the paper, so you create a loop with the paper. Make sure that you have the number on the outside so you can read your size.STEP 6: SET THE PAPER LOOP ON YOUR WRIST AND TIGHTEN IT UPSet the paper loop on your wrist, Tighten the loop by pulling the thinner paper end until you feel that it's the correct ring size.STEP 7: CHOOSE THE RIGHT SIZEAfter sizing ,To ensure the bracelet fits comfortably, add 1.5 cm. You can then add or subtract centimetres according to whether you prefer a loose, exact or tight fit.
US DIAMETER CIRCUMFERENCE 5 15.8 mm 49.6 mm 6 16.5 mm 51.8 mm 7 17.2 mm 54 mm 8 18.2 mm 57.2 mm 9 19.1 mm 60 mm 10 19.8 mm 62.2 mm 11 20.6 mm 64.8 mm 12 21.6 mm 67.9 mm 13 22.3 mm 70.1 mmMEASURE WITH CUT OUT RULER